Body Configuration:

  • Body Construction for 84”CA Chassis
  • 38,000 ft./lb. Crane Body
  • Interlocking structural sub-frame
  • 11’ body length
  • 10ga galvanneal steel (Patented) single panel side pack construction
  • 22” deep side packs
  • 50” Cargo floor width
  • 58” tall front passenger side compartment, all remaining compartments 46” tall
  • Six integrated tie downs in cargo floor (900lb rating each)
  • Double panel galvanneal steel doors (10-ga outer, 14-ga inner panels)
  • Internal stainless steel door hinges
  • Compression style T-handle door latches, keyed, rollers on latch rods (at contact points)
  • Push on automotive style rubber door seals
  • Gas door shock retainers
  • Double panel pickup style tail gate with paddle style latch
  • Integral (formed) full length of body rain gutter
  • Recessed bulkhead to protect hydraulic tank
  • 20” Work bench bumper

Included Body Options:

  • Includes integrated steps LH & RH, with galvanized steel open tread grating for sure footing
  • Includes storage in bumper with latched doors LH & RH, includes inner lath protection
  • Receiver hitch, with 7-pin RV style trailer plug
  • Raised light bar mounted at front of body
  • LED marker and stop/tail/turn lights
  • 4-LED work lights: 2-mounted on light bar, 2-mounted LH & RH of rear of body facing back.
  • LED interior compartment lights
  • Master locking system for driver and passenger side packs
  • 36 gallon hydraulic tank with sight glass
  • Zolatone on the interior of the compartments
  • Arctic package
  • Bed liner on cargo walls and cargo floor and tops of side packs

Crane Package:

  • Auto Crane model HC-7 hydraulic crane with NexStar III system
  • 7,000 lb. lift (max)
  • 38,000 ft-lb capacity
  • Full power extension to 20’
  • Power boom elevation, power hoist, and power rotation
  • 95 ft. of 3/8″ 14,700 lbs. single line break strength aircraft quality cable
  • -14 to 75 degree boom elevation
  • Heavy duty swivel block with latch
  • 370 degree rotation
  • 55 ft./min. single line speed
  • 8 GPM @ 2,750 psi hydraulic requirement
  • Automatic overload protection for hoist up, boom extend, and boom down
  • NexStar III Crane Management Systems include:
  • Proportional control
  • LCD receiver
  • LCD readout on controller
  • Pistol grip with thumb tip control of all functions
  • Angle detection of the boom and truck using two 3-axis sensors
  • Transmitter cradle installed
  • Crane boom support
  • Hydraulic in/out & up/down outriggers with rear mounted control

Air Compressor Package:

  • Auto Crane AC-40 hydraulic air compressor (mounted top of LH side pack)
  • 40 cfm @ 100psi
  • 20-gallon (2 ten gallon) air reservoir mounted under body
  • Air hose reel, ½” x 50’ air hose, with rear exit, includes FLR (Filter/lube/regulator)
in    0